How To: Install A Mercury Flo Torq II Hub Kit

Wondering what to do with the hub kit you were sold when you purchased your new prop?

Watch as our prop expert, Andreas Kuppe, explains how to install a Mercury Marine Flo-TorQ II Hub Assembly Kit.

Watch the video online or click and watch below:

See, not too scary, right?

1. Place the bushing insert inside the propeller and secure it with your rubber mallet. Remember, "the hole in the back matches the hole in the back."
2. Next is the thrust washer. Ensure it goes in lip side down and that it's pushed all the way seated down.
3. Slide your prop onto the prop shaft of your boat's engine.
4. Last is the hub, locking tab (that stops the propeller from coming off in reverse), and the lock nut.

Now you're ready to change out your prop and get on the water!

Prefer to see this demo in person? Stop by our retail location and a member of our Parts Team can walk you through it and answer any questions you may have!

Happy boating!